I've spent about 12 hours trying to get all of this setup and not sure where to go next after reviewing pretty much every forum post out there about UMC202HD. I thought it may be an issue with the interface audio out, but I can hear audio when just in a DAW or regular computer audio. Unfortunately with the UMC202HD ASIO driver, I'm unable to change the buffer as JamKazam seems to lock the buffer setting at 8. I've also tried putting the interface through Reaper DAW ASIO driver based on another forum post and that was no help either. I can't hear anything i've recorded in a private session and can't hear anything when in sessions with others (regardless of total latency). I'm using the UMC202HD audio interface and have no issues setting up the gear and getting low latency (3-4 ms) and green I/O (sometimes yellow when deleting and re-adding gear), however when I go into a session, the device input and output jitter turns red and I have absolutely no audio out. Posted by: jasonatkins9999 - 05-01-2020, 09:04 PM - Forum: Help with Audio Gear I have two questions: 1.) Is the Mackie ProFx8 compatible with JamKazam and 2.) If yes, can you provide detailed instructions to interface the Mackie ProFx8 mixer correctly with JamKazam.Īlso, can you recommend alternate external interface equipment possibilities that work best with JamKazam? I am eager to get connected.Īudio issues but with good latency and decent jitter - UMC202HD I chose the same input and output options on JamKazam.
The input and output settings on my laptop are set to USB Audio CODEC which was recommended in the Mackie Manual to allow all in and out signal to pass through the Mixer. I tried all sample rate options with no success. I am interfacing with my Mackie ProFX8 Mixer and getting this message "device sample rates do not match and are in conflict". Mackie Pro FX8 v2 is set up on the laptop with fine with Audacity, Trying to start the initial setup not sure where how/where to startĭevice sample rates do not match and are in conflict Posted by: Rhguitars - 05-01-2020, 11:10 PM - Forum: Help with Audio Gear You have to register before you can post on our site.
0 kommentar(er)
